Snowball berries of Swarovski bicone and pearl
In the example I use 4mm's vaxed beads but the berry becomes the very prettiest (in my opinion then: D) when it is made with 4mm Swarovski Bicone. It is obviously possible to do all sorts of sizes but it is good to remember that all beads have the same shape and size.
1st It would require 30 pieces of beads and a piece of nylon thread (fishing line) around 60-70 cm. Then you may want to have some kind of glue to fix the knot with.
2nd Thread the beads 5 and return wire so that the beads form a flower. Move to "flower" sits in the middle of the thread.
3rd Thread 4 pearls and turn again back through the last (this principle, follow through the entire pattern). Now, the two "flowers" next to each other and the wooden one of the wire ends through the next bead on one side (I always run to the left but the key is that you run the same side each time) so that it looks like the image below . Now you have built the foundation for the next "flower" as it is now only needed three new gems to.
4th Continue then with the wood of 3 beads, go back through the last and then back through one of the jewels in the first "flower". Repeat this three times. After this you should have almost a hemisphere. When you reach this state of wood you through two beads for the newest "flower" instead of one, now need to only two new gems to create the final "flower" in the hemisphere. Wood when the two beads, back through the last and then on to a nearby again. It can be tricky to keep the thread taut but you will learn after a ball if not before, now looks hopefully like this.
5th Put the three new gems, back through the last and then again through the two adjacent on one side. On this side of the globe have wooden man then through the next two on the left (or what direction you are selected) and not just one as it was before. Wood then two beads and perform the same procedure as before. Repeat this another two times. After this thread you now, after you have finished the last "flower", through the three beads to the left so that you are in the position shown in the picture below. I think it clearly appears that there are now only taken one bead to be clarified.
6th Wood is now at the very last bead with both ends of the wire (one in each direction) and the wooden one wire end around the single "flower" that is not beaded (see the small picture in the picture below, then all the flowers should look like). Now, just tighten a little more and tie a few knots. Cut the thread and apply a small amount of glue on the knot. Want a connective loop that you can pull a chain through so it may be easy to slip on the right before making joint so that it is stuck in the corner. This is what the final ball looks: (I added even where a ball made of Swarovski pearls
